圆弧状沉积盆地与软土单覆盖层出平面地表运动对比   总被引：2，自引：0，他引：2  

袁晓铭  李雨润  孙锐 《地震工程与工程振动》2002,22(4):16-21

采用解析方法，通过圆弧状沉积盆地与同样参数的软土均匀单覆盖层的对比，研究沉积盆地对平面SH波二维散射效应和其出平面地表运动。数值对比结果表明：（1）波垂直入射时盆地中央地表位移幅值反应，其随频率变化形式与软土单覆盖层的地表运动有较强的对应性，且此时单覆盖层地表位移幅值为其下降；（2）盆地的二维散射效应特点显著波的汇聚作用使盆地中的地表运动显著放大，总体上较软土单覆盖层的地表位移幅值要大，其频域内的最大反应则明显大于单覆盖层情况，但最大反应在盆地表面出现的位置依赖于入射波角度、盆地深宽比和盆地的软硬程度；（3）沉积盆地中地表位移运动有强烈扭转效应，且随盆地变软和入射波频率增高而增强。  相似文献   

TEM法在寻找煤矿突水巷道中的应用   总被引：3，自引：0，他引：3  

马瑞花  龚惠民 《中国煤田地质》2003,15(3):49-50

在地质勘探中,TEM法体积效应影响小,探测深度大,对低阻反映灵敏,因此,其作为一种物探手段,已被广泛应用于地球物理勘探的各个领域。TEM法在煤矿突水巷道勘探中,曲线形态为高电位单峰异常,这个特征用于煤矿充水巷道探测准确度高,效果明显。  相似文献   

西湖凹陷陆盆冲积体系河道演变规律探讨     

陈琳琳  胡佳庆  白洁 《上海国土资源》2003,(1):40-44

西湖凹陷渐新统一中新统陆盆沉积发育了类型丰富的河道沉积，本文根据陆盆充填机制对盆地演化各阶段的控制作用，从沉积层序、沉积构造、岩性组合特征诸方面探讨了盆地演化过程的河道变迁特点。  相似文献   

桩承载力时效对桩土相互作用及沉降的影响分析   总被引：2，自引：2，他引：2  

郑刚  任彦华 《岩土力学》2003,24(1):65-69

对软土中两根47 m长灌注桩分别在成桩28 d和1 750 d后进行了承载力试验，其极限承载力提高幅度达到30％左右。分析了单桩承载力随时间提高(称为时效)的机理，提出了单桩承载力时效对桩筏基础桩土相互作用影响的分析方法，并结合工程实例进行了分析。  相似文献   

武汉长江底钻孔同位素单井法地下水流速、流向测试   总被引：4，自引：1，他引：4  

韩庆之  陈辉  万凯军  万讯平 《水文地质工程地质》2003,30(2):74-76,82

本文论述了在武汉市长江底部第四纪孔隙含水层中用单井稀释法测定地下水流速、流向实验的过程和结果。并对在这种试验条件下所得的测定结果进行分析讨论,得出了相应的结论。测试结果表明:武汉长江底部JC II 6号钻孔处地下水流向从上到下都受到地表长江水流的影响。上部受到影响大,而深部较弱,地下水流向从上到下逐渐向东偏转35°左右。上部中细砂层中的地下水流速,大于下部粗中砂层中地下水流速。本次测试由于测定点靠近江心地下水排泄带,其地下水和地表水的水头差0 5m左右,试验虽然采取了特殊的施工工艺,也还可能受到垂向流的微小影响,使测试结果中的水流速度比实际地下水水流速度可能要稍偏大些。但因本点水文地质条件决定了三段之间或地下水流和江水之间无明显的水头差,所以引起的误差不大,可以忽略不计。  相似文献   

VORTEX FLOW FIELD IN A SCOUR HOLE AROUND ABUTMENTS     

Abdul Karim BARBHUIYA  Subhasish DEY 《国际泥沙研究》2003,18(4)

The three-dimensional flow field in a scour hole around different abutments under a clear water regime was experimentally measured in a laboratory flume, using the Acoustic Doppler Velocimeter (ADV). Three types of abutments used in the experiments were vertical-wall (rectangular section), 45° wing-wall (45° polygonal section) and semicircular. The three-dimensional time-averaged velocity components were detected at different vertical planes for vertical-wall abutment and azimuthal planes for wing-wall and semicircular abutments. The velocity components were also measured at different horizontal planes. In the upstream, presentations of flow field through vector plots at vertical / azimuthal and horizontal planes show the existence of a primary vortex associated with the downflow inside the scour hole. On the other hand, in the downstream, the flow field shows a reversed flow near the abutments having a subsequent recovery with a passage of flow as a part of the main flow. The data presented in this p  相似文献   

Inelastic displacement ratios for evaluation of existing structures     

Jorge Ruiz‐García  Eduardo Miranda 《地震工程与结构动力学》2003,32(8):1237-1258

Results of a detailed statistical study of constant relative strength inelastic displacement ratios to estimate maximum lateral inelastic displacement demands on existing structures from maximum lateral elastic displacement demands are presented. These ratios were computed for single‐degree‐of‐freedom systems with different levels of lateral strength normalized to the strength required to remain elastic when subjected to a relatively large ensemble of recorded earthquake ground motions. Three groups of soil conditions with shear wave velocities higher than 180m/s are considered. The influence of period of vibration, level of lateral yielding strength, site conditions, earthquake magnitude, distance to the source, and strain‐hardening ratio are evaluated and discussed. Mean inelastic displacement ratios and those associated with various percentiles are presented. A special emphasis is given to the dispersion of these ratios. It is concluded that distance to the source has a negligible influence on constant relative strength inelastic displacement ratios. However, for periods smaller than 1s earthquake magnitude and soil conditions have a moderate influence on these ratios. Strain hardening decreases maximum inelastic displacement at a fairly constant rate depending on the level of relative strength for periods of vibration longer than about 1.0s while it decreases maximum inelastic displacement non‐linearly as the period of vibration shortens and as the relative‐strength ratio increases for periods of vibration shorter than 1.0s. Finally, results from non‐linear regression analyses are presented that provide a simplified expression to be used to approximate mean inelastic displacement ratios during the evaluation of existing structures built on firm sites. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

Mid‐Holocene sub‐blanket‐peat alluvia and sediment sources in the upper Liffey valley,Co. Wicklow,Ireland     

Martin Thorp  Peter Glanville 《地球表面变化过程与地形》2003,28(9):1013-1024

A recently exposed section across a ?rst‐order valley buried beneath the regional blanket peat on hillside slopes in the upper Liffey valley, Co. Wicklow, is described. The section shows two alluvia within a shallow valley form underlain by an extensive boulder and stone line over regional till and weathered granite. ¹⁴C dates from wood in the alluvia indicate the older alluvium to have formed between 4324 ± 53 BP and 4126 ± 45 BP and the younger between 3217 ± 53 BP and 2975 ± 53 BP . The basal layer of the overlying peat yielded a date of 2208 ± 61 BP . The younger alluvium shows the effects of soil paludi?cation prior to the peat expansion. Dated pollen analyses elsewhere in the upper catchment con?rm the spread of blanket peat over most areas above 350 m after 4000–3600 BP . The buried valley was contributing sediments to the mid‐Holocene ?oodplains in the upper Liffey valley prior to the extension of blanket peat over the catchment after which sediment yields from it and the other catchment slopes declined. Copyright © 2003 John Wiley & Sons, Ltd.  相似文献   

A procedure for evaluating seismic energy demand of framed structures     

Chung‐Che Chou  Chia‐Ming Uang 《地震工程与结构动力学》2003,32(2):229-244

Energy serves as an alternative index to response quantities like force or displacement to include the duration‐related seismic damage effect. A procedure to evaluate the absorbed energy in a multistorey frame from energy spectra was developed. For low‐ to medium‐rise frames, it required a static pushover analysis of the structure to determine the modal yield force and ductility factor of an equivalent single‐degree‐of‐freedom system for the first two modes. The energy spectra were then used to determine the energy contribution of each mode. A procedure was also developed to distribute the energy along the frame height based on energy shapes. This study showed that the second‐mode response in some cases needs to be considered to reflect the energy (or damage) concentration in the upper floors. Copyright © 2002 John Wiley & Sons, Ltd.  相似文献   

基于图像区域特征的细胞识别方法及实现   总被引：5，自引：0，他引：5  

程勇  傅德胜 《南京气象学院学报》2003,26(5):712-716

先提取目标物体的面积、中心矩、圆形度、细长度、核浆比等区域特征。然后采用单原型模式表征方法，利用集群分析技术中最小距离分类器，构造判别函数，并依此作为识别类型的依据。最后，通过对鳞细胞的区域特征进行计算比较，选择出能够较明显地辨别出类别的特征向量，建立判别函数并对结果的可信度进行了讨论。  相似文献